LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2003 >> Escalade EXT >> Repair and Diagnosis >> Transmission >> Transfer Case >> Transfer Case - Servicing >> Removal & Installation >> Encoder Motor (NVG 246) >> Removal

Encoder Motor (NVG 246): Removal

  1. Raise and support vehicle.
  2. Remove the transfer case shield, if equipped. See TRANSFER CASE SHIELD  .
  3. Remove the front drive shaft. See appropriate DRIVE SHAFTS & UNIVERSAL JOINTS article in DRIVELINE/AXLES.
  4. Disconnect the transfer case switch electrical connector (2). See Fig 1 .
  5. Disconnect the encoder motor electrical connector (7).
  6. Remove the encoder motor bolts. See Fig 2 .
  7. Remove the encoder motor.
  8. Remove the actuator insulator gasket.
  9. If replacing the encoder motor, remove the locating pins from the old motor.
Fig 1: Identifying Transfer Case Electrical Connectors
G00211890Courtesy of GENERAL MOTORS CORP.
Fig 2: Removing/Installing Encoder Motor Assembly
G00209680Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals