Tools Required

WARNING: This page is about a different car, the 2004 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.

J 45845 Caster and Camber Adjusting Tool. See Special Tools and Equipment .

Fig 1: Loosening Lower Control Arm To Frame Bolt

Courtesy of GENERAL MOTORS CORP.

Install J 45845 to the lower control arm and the frame. See Special Tools and Equipment .
Loosen the lower control arm to frame bolt.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Adjust the camber angle by turning the turnbuckle on J 45845 until the specifications have been met. See Special Tools and Equipment .
Tighten: Tighten the bolt to 150 N.m (111 lb ft).
Verify that the camber is still with specifications. Refer to Wheel Alignment Specifications .
Adjust the rear toe. Refer to Rear Toe Adjustment .