LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2003 >> Escalade EXT >> Repair and Diagnosis >> External Pages >> Different car >> Section 639 (Supplemental Inflatable Restraint System) >> Repair Instructions >> Inflatable Restraint Front End Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: EFS & Connector
    GM808285Courtesy of GENERAL MOTORS CORP.
  1. Remove any dirt, grease, or other impurities from the mounting surface.
  2. Position the sensor (2) horizontally on the mounting surface.
  3. Point the arrow on the sensor toward the front of the vehicle.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the mounting fasteners.

    Tighten:  Tighten the fastener (1) to 9 N.m (80 lb in).

  5. Connect the harness wiring connector to the front end sensor.
  6. Install the CPA to the wiring harness connector on the front end sensor.
  7. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 1 .
scientia non olet · About LEMON Manuals