Removal Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 GMC Yukon XL, 2004 GMC Yukon, 2004 Chevrolet Tahoe, 2004 Chevrolet Suburban, and 2004 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Do NOT swap digital radio receivers between vehicles. Swapping digital receivers between vehicles will activate the digital radio Theftlock®, and "XM Theftlock®" will display.
- Remove the right side junction block from the instrument panel (I/P). Refer to Instrument Panel Electrical Center or Junction Block Replacement - Right
in Wiring Systems.
Do not disconnect the electrical connectors.
- Lower the I/P compartment door to the full open position.
- From the junction block opening, remove the 2 retaining screws (1).
- Pull the receiver and bracket assembly from the I/P compartment opening.
- Disconnect the wire connector.
- Disconnect the coaxial cables from the receiver.
- Remove the receiver and bracket assembly from the I/P.