LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2003 >> Escalade EXT >> Repair and Diagnosis >> External Pages >> Different car >> Section 455 (Entertainment System) >> Repair Instructions >> Receiver Replacement - Digital Radio >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 GMC Yukon XL, 2004 GMC Yukon, 2004 Chevrolet Tahoe, 2004 Chevrolet Suburban, and 2004 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the coaxial cables.
  2. Connect the wire connector.
  3. Install the receiver and bracket assembly to the I/P.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the 2 retaining screws (1).

    Tighten:  Tighten the screws to 1.6 N.m (14 lb in).

    5. Fig 1: Connecting Wire Connector & Installing Receiver/Bracket Assembly Screws
    GM854856Courtesy of GENERAL MOTORS CORP.
  5. Install the right side junction block to the I/P. Refer to Instrument Panel Electrical Center or Junction Block Replacement - Right in Wiring Systems.
  6. Close the I/P compartment door.
  7. Perform the setup procedure for the digital radio receiver. Refer to Digital Radio Receiver Setup .
scientia non olet · About LEMON Manuals