LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2003 >> Escalade EXT >> Repair and Diagnosis >> External Pages >> Different car >> Section 455 (Entertainment System) >> Repair Instructions >> Microphone Replacement - Radio Volume Compensator Interior >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 GMC Yukon XL, 2004 GMC Yukon, 2004 Chevrolet Tahoe, 2004 Chevrolet Suburban, and 2004 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the radio volume compensator microphone (2) to the floor console side trim panel.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the radio volume compensator microphone screws (1).

    Tighten:  Tighten the screws to 2 N.m (18 lb in).

  3. Align the side trim panel to the floor console and connect the radio volume compensator microphone (2) electrical connector.
    4. Fig 1: Installing Radio Volume Compensator Microphone & Screws
    GM1376879Courtesy of GENERAL MOTORS CORP.
  4. Install the electrical connector hold down clip to the floor console.
  5. Align the trim panel to the floor console, push the panel towards the floor console to engage the panel clips.
  6. Install the front console side panel screw (1).

    Tighten:  Tighten the screws to 2 N.m (18 lb in).

    7. Fig 2: Locating Console Side Panel Screw
    GM1207752Courtesy of GENERAL MOTORS CORP.
  7. Move the front seat fully forward.
  8. Install the rear console side panel screw (2).

    Tighten:  Tighten the retaining screw to 2 N.m (18 lb in).

  9. Reposition the inboard seat track trim (1).
    10. Fig 3: View Of Seat Track Trim & Rear Console Side Panel Screw
    GM1207757Courtesy of GENERAL MOTORS CORP.
  10. Install the floor console storage bin. Refer to Console Storage Bin Replacement (Expect Pro) in Instrument Panel, Gages and Console.
  11. Install the floor console end panel. Refer to Center Console End Panel Replacement in Instrument Panel, Gages and Console.
  12. Install the floor console cupholder. Refer to Cupholder Replacement (Non-Luxury) , Cupholder Replacement (Luxury) , Cupholder Replacement (Rear) or Cupholder Replacement (Platinum) in Instrument Panel, Gages and Console.
  13. Install the floor console bezel. Refer to Bezel Replacement - Floor Console (Non-Luxury Upper) or Bezel Replacement - Floor Console (Luxury Upper) in Instrument Panel, Gages and Console.
scientia non olet · About LEMON Manuals