Installation Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 GMC Yukon XL, 2004 GMC Yukon, 2004 Chevrolet Tahoe, 2004 Chevrolet Suburban, and 2004 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- From outside the vehicle, tie the wire to the new antenna cable and base assembly.
- From inside the vehicle, pull on the long wire until the cable can be connected and grommet seated.
- Install the cable grommet to the body.
- Remove the wire and connect the antenna cable to the cable extension.
- Install the 3 bolts.
Tighten: Tighten the bolts to 5 N.m (44 lb in).
- Install the antenna mast.
Tighten: Tighten the mast to 6 N.m (53 lb in).
- Install the outboard section of the cowl vent grille panel.
- Install the I/P trim panel. Refer to Trim Panel Replacement - Instrument Panel (I/P) Upper in Instrument Panel, Gages and Console.
NOTE:
Refer to Fastener Notice
in Cautions and Notices.
NOTE:
Use tape on the tool surface so that you do not damage the paint on the antenna mast.