Installation Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 GMC Yukon XL, 2004 GMC Yukon, 2004 Chevrolet Tahoe, 2004 Chevrolet Suburban, and 2004 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Position the seat back frame on the seat.
- Install the recliner arm attachment bolts (2).
Tighten: Tighten the bolts to 53 N.m (39 lb ft).
- Install the inboard pivot bolt (1).
Tighten: Tighten the bolt to 35 N.m (26 lb ft).
- Install the seat belt retractor. Refer to Seat Belt Retractor Replacement - Left Front or Seat Belt Retractor Replacement - Right Front in Seat Belts.
- Install the lumbar assembly (or power lumbar/bolster assembly if equipped). Refer to Lumbar Replacement - Front Seat .
- Install the seat back trim cover and pad. Refer to Seat Back Cover and Pad Replacement - Front (W/O ULT) or Seat Back Cover and Pad Replacement - Front (W/ULT) .
- Connect the lumbar cable (6) underneath the seat cushion (disconnect the wire harness if equipped with power lumbar).
- Install the seat trim panel. Refer to Trim Panel Replacement - Front Seat .
- Install the head restraint and guides. Refer to Head Restraint Replacement (Cadillac) or Head Restraint Replacement (Non-Cadillac) or Head Restraint Replacement (Folding) .
- Install the seat into the vehicle. Refer to Seat Replacement - Front Bucket .
NOTE:
Refer to Fastener Notice
in Cautions and Notices.