LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2003 >> Escalade EXT >> Repair and Diagnosis >> External Pages >> Different car >> Section 281 (Glass/Windows/Mirrors) >> Power Window SUBSWITCH Removal/Installation

Power Window SUBSWITCH Removal/Installation

WARNING: This page is about a different car, the 2004 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable.
  2. Remove the clips B using a flathead screwdriver wrapped with protective tape.
  3. Remove the switch panel from the door trim while sliding it in the direction of the arrow as shown in the figure.
  4. Disconnect the power window subswitch connector.
    Fig 1: Locating Power Window Subswitch Clip & Tabs
    G02566722Courtesy of MAZDA MOTORS CORP.
  5. Remove the screws, then remove the power window subswitch.
  6. Install in the reverse order of removal.
    Fig 2: Removing/Installing Power Window Subswitch
    G02566723Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals