Installation Procedure
- Align the marks made during the removal procedure on the steering shaft and the steering wheel.
- Install the steering wheel onto the steering shaft.
- Install the steering wheel nut to the steering shaft.
Tighten: Tighten the nut to 40 N.m (29 lb ft).
- Install the horn switch. Refer to Horn Switch Replacement - On Vehicle .
- Install the inflator module. Refer to REMOVAL & INSTALLATION (DRIVER-SIDE) in SIR.
- Enable the SIR system. Refer to DISABLING SYSTEM in SIR.
NOTE:
Refer to FASTENER NOTICE
in Cautions and Notices.