Removal & Installation: Generator: Removal
- Disconnect battery negative cable.
- Remove drive belt.
- Remove radiator support sight shield.
- Remove upper front mounting bolt from generator.
- Raise and support vehicle
- Remove engine splash shield.
- Remove bolts securing the generator access cover to the front compartment lower panel.
- Remove generator access cover.
- Disconnect wiring harness connector from the generator.
- Reposition protective cover from the generator output BAT terminal for access.
- Remove generator output BAT terminal nut and disconnect the positive lead from the generator.
- Loosen rear generator bracket from the engine.
- Remove top bolt.
- Remove front lower mounting bolt.
- Remove lower rear mounting bolt.
- Remove upper rear mounting bolt.
- Secure generator above the A/C compressor clutch pulley, in order to remove the A/C compressor/generator front bracket.
- Remove the 3 bolts securing A/C compressor/generator front bracket to engine and A/C compressor.
- Remove A/C compressor/generator front bracket.
- Rotate generator and remove it from vehicle.