Shift Interlock Solenoid (Console Shift)
- Using a thin bladed tool or a hook tool, pry upward on the rear edge of the console trim plate in order to disengage 4 of the 6 clips retaining the trim plate. Lift the rear of the trim plate in order to disconnect the traction control switch electrical connector. See Figure
.
- Push down lightly on the front of the console trim plate and pull towards the rear in order to avoid interference with the storage compartment door trim when disengaging the front console trim panel clips. Lift and remove trim plate. Adjust the shift cable as follows:
- Place the shifter into the Neutral position.
- Loosen the shifter adjuster nut.
- Tighten the adjuster nut to 18 ft. lbs (25 N.m).