Test C: Charge Indicator Inoperative
- If diagnostic system check was not performed, PERFORM ENGINE ELECTRICAL DIAGNOSTIC SYSTEM CHECK under SELF-DIAGNOSTIC SYSTEM. If diagnostic system check was performed, go to next step.
- Turn ignition switch to RUN position. If charge indicator light illuminates, problem is intermittent. Check wiring and connections. If charge indicator light does not illuminate, go to next step.
- Turn switch to OFF position. Disconnect charge indicator light circuit from generator. Turn ignition switch to RUN position. If charge indicator light illuminates, perform TEST A: CHARGING SYSTEM TEST . If charge indicator light does not illuminate, go to next step.
- Test charge indicator light circuit for a high resistance or an open. See WIRING DIAGRAMS . If problem exists, repair circuit as necessary. After repair, go to step 7 . If problem does not exist, go to next step.
- Inspect Instrument Panel Cluster (IPC) harness connector for poor connections. If problem exists, repair as necessary. After repair, go to step 7 . If connections are okay, go to next step.
- Replace IPC. See ANALOG INSTRUMENT PANELS - CATERA article. After repair, go to next step.
- Operate system to verify repair. If system is not operating correctly, repeat test beginning at step 2 .