LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2000 >> Seville STS >> Repair and Diagnosis >> External Pages >> Different car >> Section 36 (Steering Wheel And Steering Column) >> Repair Instructions >> Steering Column Control Module Programming >> Tilt/Telescoping Soft Stop Programming Procedure

Tilt/Telescoping Soft Stop Programming Procedure

WARNING: This page is about a different car, the 2002 Cadillac Seville. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition to ON, leaving the engine off.
  2. To set the tilt up soft stop, press the tilt/telescoping COLUMN UP switch at least eight times or until the column moves, then release the switch.
  3. Press the tilt/telescoping COLUMN UP switch and hold the switch until the column travels all the way up, and continue to hold the switch about a second after motion stops at the mechanical end of travel. The soft stop for the column up position is now set. The tilt/telescoping module automatically goes back to the normal mode of operation.
  4. Repeat steps 2 and 3, using the COLUMN DOWN switch, to set the column down position soft stop.
  5. Repeat steps 2 and 3, using the COLUMN IN switch, to set the column in position soft stop.
  6. Repeat steps 2 and 3, using the COLUMN OUT switch, to set the column out position soft stop.
scientia non olet · About LEMON Manuals