Voltmeter Display High Or Low
- Disconnect generator connector C1 (Red wire). Check voltage at harness connector C1. If battery voltage exists, go to step 3 . If battery voltage does not exist, go to next step.
- Locate and repair poor connection or open in Red wire between battery and starter and/or starter and generator. See WIRING DIAGRAMS . Go to next step.
- Reconnect generator connector. Start engine and run at fast idle. Turn off accessories. Check voltage at battery terminals. If voltage is 12.5-14.5 volts, go to step 5 . If voltage is not 12.5-14.5 volts, go to next step.
- Replace generator. See REMOVAL & INSTALLATION . Go to step 6 .
- Load test generator. Replace generator as needed. If generator is okay, replace battery. Go to next step.
- Reconnect all connectors and recheck system. If system is not operating properly, go to step 1 .