Left Mirror
- Perform MEMORY SYSTEM CHECK under TESTING - SYSTEM CHECKS. Go to next step.
- Disconnect left outside mirror connector C1. Connect a fused jumper (20-amp) wire between component-side of outside mirror connector C1, terminal "A" (Light Blue wire) and battery voltage. Connect another fused jumper wire between component-side of outside mirror connector C1, terminal "B" (White wire) and ground. If left/right motor runs, go to next step. If left/right motor does not run, go to step 6).
- Disconnect Memory Mirror Module (MMM) Blue, 32-pin connector C1. Using DVOM, check resistance between MMM harness connector terminal E11 (White wire) and outside mirror harness connector C1, terminal "B" (White wire). If resistance is 5 ohms or less, go to next step. If resistance is not 5 ohms or less, go to step 7).
- Check resistance between MMM harness connector terminal E13 (Light Blue wire) and outside mirror harness connector C1, terminal "A" (Light Blue wire). If resistance is 5 ohms or less, go to next step. If resistance is not 5 ohms or less, go to step 8).
- Replace Memory Mirror Module (MMM).
- Replace left outside mirror. See MIRRORS - POWER article.
- Repair open in circuit No. 81 (White wire) between left outside mirror and MMM. See WIRING DIAGRAMS .
- Repair open in circuit No. 82 (Light Blue wire) between left outside mirror and MMM. See WIRING DIAGRAMS .