Removal & Installation (3.8L)
WARNING: This page does not describe the selected car, but rather 36 other vehicles, including the 1999 Saturn SW2, 1999 Saturn SW1, 1999 Saturn SL2, 1999 Saturn SL1, and 1999 Saturn SL. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect negative battery cable. Disconnect 14-pin connector at ignition control module. Disconnect spark plug wires from coil pack. Remove 6 screws retaining coils to ignition control module. Remove ignition coils from module.
- Remove screws and washers securing ignition control module to bracket. Remove ignition control module. To install, reverse removal procedure. Tighten retaining screws to specification. See TORQUE SPECIFICATIONS .