Trouble Shooting Hints

On all models, note condition of SECURITY indicator light. If indicator stays on or flashes continuously, see ANTI-THEFT SYSTEMS article in ACCESSORIES & EQUIPMENT. Check starter solenoid terminals and battery grounds. Check for proper installation of aftermarket electronic equipment. Perform self-diagnostic system test, to be certain no trouble codes are stored in PCM memory which may lead to misdiagnosis. See TESTS W/CODES article in ENGINE PERFORMANCE.

Check 80-amp V2 fuse, located in power distribution fuse block. See COMPONENT LOCATIONS  table. If fuse is open, check for a short to ground in Red wire between power distribution fuse block connector terminal "X" and ignition switch connector terminal "Y". Ensure battery voltage exists at voltage side of 80-amp V2 fuse. If battery voltage does not exist, check for open in Red wire between power distribution fuse block connector terminal No. 1 and battery positive terminal.