Removal & Installation: Starter: Installation
- Before installing starter onto engine, tighten inner solenoid terminal nuts to ensure they are secure in cap. Starter failure may occur due to terminal or cap damage. Install starter and wiring. Tighten starter mounting bolts to specification. See TORQUE SPECIFICATIONS .
- Install intake manifold with throttle body attached. Tighten intake manifold bolts and studs to specification by staring at center of manifold and working outward in a circular pattern. See TORQUE SPECIFICATIONS . When connecting fuel line quick connect fittings apply a few drops of clean engine oil to male ends. After reconnecting fuel lines, turn ignition switch to ON position for 2 seconds, then turn ignition switch to OFF position for 10 seconds. Turn ignition switch back to ON position and check for fuel leaks. To complete installation, reverse removal procedure. Tighten starter mounting bolts to specification. See TORQUE SPECIFICATIONS .