LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 1997 >> Catera >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - Tests W/Codes - 3.0L >> Diagnostic Trouble Codes >> DTC P0602 - ECM Not Programmed >> Diagnostic Procedures

Diagnostic Procedures

  1. Perform ON-BOARD DIAGNOSTIC (OBD) SYSTEM CHECK. See the BASIC TESTING article. After performing OBD system check, go to next step.
  2. Flash ECM with correct software. New ECM must be programmed with theft deterrent module frequency code currently on vehicle. If DTC P0602 resets, go to next step. If DTC P0602 does not reset, go to step 5).
  3. Verify that equipment being used is functioning properly and that all cable connections are clean and tight. Attempt to flash ECM again. If DTC P0602 resets, go to next step. If DTC P0602 does not reset, go to step 5).
  4. Replace ECM, then go to step 2).
  5. Using scan tool, clear DTCs. Turn ignition off for 15 seconds. Start engine and operate vehicle. Check for DTCs. If DTC P0602 is set, go to step 2). If DTC P0602 is not set, go to next step.
  6. If other DTCs were present during OBD system check and have not been diagnosed, go to applicable DTC. If no other DTCs are present, system is okay.
scientia non olet · About LEMON Manuals