Engine Does Not Crank
- Perform PASS-KEY II(R) SYSTEM CHECK. With fused jumper wire still installed, using DVOM, measure voltage at theft deterrent relay connector terminal No. 30 (Red wire) while attempting to start engine. If battery voltage is not present, repair open in Red wire between theft deterrent relay and ignition switch.
- If battery voltage is present, using DVOM, measure voltage at starter solenoid terminal "S" (Yellow wire) while attempting to start engine. If battery voltage is present, diagnose problem with starting or charging system. See appropriate GENERATOR & REGULATOR or STARTER article in ELECTRICAL section. If battery voltage is not present, repair open in Yellow wire between theft deterrent relay connector terminal No. 87 and starter solenoid terminal "S".