Keyless Entry Programming

Perform the following when replacing Keyless Entry Module or either Transmitter

1. Turn ignition switch to OFF position.
2. Jumper ALDL terminal G (PPL/WHT) wire to terminal A (BLK/WHT) wire. Door locks will lock and unlock and trunk release will activate in approximately 2 seconds. See Fig 1 .
3. Press any button on one transmitter. Door locks will lock and unlock and trunk release will activate in approximately 2 seconds. The first transmitter is now programmed.
4. Repeat previous step with the other transmitter. If only one transmitter is being used, go to next step.
5. Disconnect jumper from program connector.

Fig 1: Identifying ALDL ConnectorTerminals

Courtesy of GENERAL MOTORS CORP.