PCM Output Displays

The PCM OUTPUTS option provides the ability to cycle PCM controlled Outputs. The DIC display identifies the solenoid or relay, and the state that the PCM is commanding that device. HI indicates that the solenoid or relay is energized, and LO indicates that the solenoid or relay is de-energized. The PCM ouputs tests can only by done at key "ON" engine "OFF". The PCM outputs available are as follows:

1. EO00 - CYCLE NONE
   
   No outputs are cycled.
2. EO01 - CAN PURGE
   
   Canister Purge Solenoid.
3. EO02 - VCC SOL
   
   Viscous Converter Clutch Solenoid.
4. EO04 - EGR SOL
   
   Electronic Vacuum Regulator Valve (EVRV).
5. EO05
   
   Not Valid.
6. EO06
   
   Not Valid.
7. EO07 - ISC MOTOR
   
   ISC MOTOR.
8. EO08 - CVS
   
   Cruise Vent Solenoid.
9. EO09 - CVS
   
   Cruise Vacuum Solenoid.
10. EO10 - 2-3 SHIFT SOLENOID
    
    2-3 SHIFT SOLENOID.
11. EO11 - 3-4 SHIFT SOLENOID
    
    3-4 SHIFT SOLENOID
12. EO20 - A/C RELAY
    
    A/C Clutch Control Relay.
13. EO99 - CYCLE ALL
    
    Cycle All Outputs.