Output Displays

The ECM OUTPUTS option provides the ability to cycle ECM controlled Outputs. The DIC display identifies the solenoid or relay, and the state that the ECM is commanding that device. HI indicates that the solenoid or relay is energized, and LO indicates that the solenoid or relay is de-energized. The ECM ouputs tests can only by done at key "ON" engine "OFF". The ECM outputs available are as follows:

1. EO00 - CYCLE NONE
   
   No outputs are cycled.
2. EO01 - CAN PURGE
   
   Canister Purge Solenoid.
3. EO02 - VCC SOL
   
   Viscous Converter Clutch Solenoid.
4. EO03 - EGR SOL
   
   Electronic Vacuum Regulator Valve (EVRV).
5. EO04 AIR SWITCH
   
   AIR Switch Solenoid.
6. EO05 - AIR DIVERT
   
   AIR Divert Solenoid.
7. EO06 - ISC MOTOR
   
   Idle Speed Control Solenoid.
8. EO07 - CRUISE VENT
   
   Cruise Vent Solenoid.
9. EO08 - CRUISE VACUUM
   
   Cruise Vacuum Solenoid.
10. EO09 - SHIFT A
    
    Canister Purge, EGR, ISC, Cruise Vent, Electric Switching Valve (ESV).
11. EO10 - SHIFT B
    
    Cruise Vacuum, Electric Divert Valve (EDV) , VCC, A/C Relay.
12. EO20 - A/C RELAY
    
    A/C Clutch Control Relay.
13. EO99 - CYCLE ALL
    
    Cycle All Outputs.