C: Starter Enable Relay Test
Measure voltage at the STARTER ENABLE RELAY (Disconnected). The condition should be with the ignition switch in the START position.
C: STARTER ENABLE RELAY TEST(1)
| Measure Between | Correct Voltage | For Diagnosis | ||
|---|---|---|---|---|
| 4 (Yellow) & Ground | Battery | See 1 | ||
| 5 (Yellow) & Ground | Battery RELAY TEST. | See 1 | ||
|
||||
- Check Yellow (5) wire for an open. If wire is good but voltage is not present, see DIAGNOSIS OF STARTER AND CHARGING CIRCUITS.
- Connect a fused jumper between terminals 4 (Yellow) wire and 1 (Yellow) wire of the Starter Enable Relay Connector. Turn Ignition Switch to START.
- If engine cranks, proceed to step 3.
- If engine does not crank, see DIAGNOSIS OF STARTER AND CHARGING CIRCUITS.
- Reconnect the Starter Enable Relay and connect a fused jumper from terminal A3 (Black/Yellow) wire of the Pass Key Decoder Module to ground. Turn Ignition Switch to START.
- If engine cranks, replace the Pass Key Decoder Module.
- If engine does crank, check the Black/Yellow (625) wire for an open. If wire is OK, replace the Starter Enable Relay.