Hard Start
- If engine starts but then dies immediately, see appropriate ENGINE CRANKS BUT WILL NOT RUN diagnostic chart in COMPUTERIZED ENGINE CONTROL section. Check for sticking or binding TPS.
- Check for high TPS voltage with throttle closed. Voltage should be less than .7 volts. Check for high resistance in coolant sensor circuit or coolant sensor.
- Check fuel pressure and fuel pump relay. See appropriate A-7 FUEL SYSTEM DIAGNOSIS CHART in COMPUTER CONTROLS section. Check for contaminated fuel. Check in-tank fuel pump check valve operation.
- If problem exists in cold weather only, check cold start valve operation. Check fuel evaporation system. Check EGR operation. Check ignition system.
- Check spark plug condition. On 2.8L VIN S, 5.0L and 5.7L, if engine starts and immediately stalls, disconnect distributor by-pass line. If engine starts and runs okay, replace pick-up coil. If engine starts and then stalls, disconnect MAF sensor (if equipped). Replace MAF sensor if engine runs and sensor connections are okay.