Removal & Installation
WARNING: This page is about the DeVille 2D Coupe, which is a different variant/trim than selected.
TRANS ID - 400, 425
| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| 2.8 | 2.2 | C | ||
| Combination Procedure: BAND: Remove & Replace: | ||||
| Front | 1.0 | A | ||
| Rear or Both | 1.7 | A | ||
| Combination Procedure: CARRIER PINIONS: Remove & Replace: | ||||
| Both | 2.9 | B | ||
| Output | 2.4 | B | ||
| Reaction | 2.2 | B | ||
| Combination Procedure: CONVERTER: Drain & Test: | ||||
| 0.2 | C | |||
| Combination Procedure: DIRECT CLUTCH: Overhaul: | ||||
| 1.1 | A | |||
| Combination Procedure: FLYWHEEL: Remove & Replace: | ||||
| 0.2 | 0.2 | C | ||
| Combination Procedure: FORWARD CLUTCH: Overhaul: | ||||
| 1.3 | A | |||
| Combination Procedure: FRONT PUMP: Remove & Replace: | ||||
| 0.5 | B | |||
| Combination Procedure: FRONT PUMP (REMOVED): Overhaul: | ||||
| 0.5 | B | |||
| Combination Procedure: FRONT PUMP BUSHING & SEAL: Remove & Replace: | ||||
| 0.3 | B | |||
| Combination Procedure: INTERMEDIATE CLUTCH PLATES: Remove & Replace: | ||||
| 1.1 | A | |||
| Combination Procedure: INTERMEDIATE SPRAG: Remove & Replace: | ||||
| 1.5 | A | |||
| Combination Procedure: LOW SPRAG: Remove & Replace: | ||||
| 2.5 | A | |||
| Combination Procedure: OIL PUMP SEAL: Remove & Replace: | ||||
| Front | 0.2 | B | ||
| Combination Procedure: OUTPUT SHAFT: Remove & Replace: | ||||
| 2.2 | B | |||
| Combination Procedure: PRESSURE CONTROL VALVE: Overhaul: | ||||
| 0.8 | B | |||
| Combination Procedure: PUMP TO CASE GASKET: Remove & Replace: | ||||
| 0.3 | B | |||
| Combination Procedure: SPEEDOMETER DRIVE GEAR: Remove & Replace: | ||||
| 1.4 | B | |||
| Combination Procedure: TORQUE CONVERTER: Remove & Replace: | ||||
| 0.1 | C | |||
| Combination Procedure: TRANSMISSION ASSEMBLY: Replace: | ||||
| 0.6 | C | |||
| Combination Procedure: TRANSMISSION CASE: Remove & Replace: | ||||
| 2.5 | A | |||