Automatic Choke Setting

Remove choke assembly from manifold, to disengage choke. coil rod from vacuum break lever. Reinstall choke coil assembly, but do not Install choke coil rod into hole in lever. With choke valve completely closed, fast idle earn in cold start position, pull choke coil rod upward to end of travel, against stop in choke coil housing. Upper end of rod should be positioned in gauging notch. Bend rod at offset to adjust. Remove choke coil assembly and reinstall, putting upper end of rod into hole in vacuum break lever and tightening assembly to manifold. The "L" gauging notch is a one notch leaner position, the "R" a one notch richer position.