Intake Manifold Installation
Position new gasket on cylinder head and new seals at front and rear rails of block, using suitable sealer. Install manifold and bolts. Tighten to specifications.
NOTE:
Cement sheet metal gasket and shield to engine.
| PISTONS, PINS, RINGS | ||||||
|---|---|---|---|---|---|---|
| Engine | PISTONS | PINS | RINGS | |||
| Clearance | Piston Fit | Rod Fit | Rings | End Gap | Side Clearance | |
| 472" | ||||||
| 1968-69 | .0006.0010" | .0001-.0002" | Press Fit | Comp. Oil | .013.025".015.055" | .0017-.004" None |
| 472" & 500" | ||||||
| 1970-73 | .0006.0010" | .0002-.0004" | Press Fit | Comp. Oil | .013.025".015.055" | .0017.004" None |