Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- Clean the contact surfaces between the power transfer unit and the transmission.
- Power Transfer Unit Face Seal (1) - Install NEW
- Support the power transfer unit with a suitable jack, and secure with suitable straps.
- Power Transfer Unit Case (1) @Transmission - Install
- Power Transfer Unit Bolt (1) - Install and tighten [3x] 100N.m (74 lb ft)CAUTION:
- Power Transfer Unit Bolt (1) - Install and tighten100N.m (74 lb ft)
- Power Transfer Unit Vent Hose (2) @Power Transfer Unit Case (3) - Connect
- Power Transfer Unit Vent Hose Retainer (1) @Turbocharger Outlet Duct Connector - Connect
- Propeller Shaft@Transfer Case - Install - Propeller Shaft Replacement
- Power Transfer Unit Bracket (2) - Install - Power Transfer Unit Bracket Replacement
- Position the wiring harness then install the retainers (2).
- Electrical Connector (1) - Connect [2x]
- Fill the power transfer unit to the bottom of the power transfer unit fill plug hole with the recommended fluid. Adhesives, Fluids, Lubricants, and Sealers , and Approximate Fluid Capacities
- Power Transfer Unit Heat Shield (2) - Install - Power Transfer Unit Heat Shield Replacement
- Front Wheel Drive Shaft- Right Side (1) - Install - Front Wheel Drive Shaft Replacement - Right Side