Component Testing

A23C Liftgate Latch-Dynamic Test

1. Ignition/Vehicle - Off
2. Disconnect the electrical connector: A23C Liftgate Latch
3. Manually move the A23C Liftgate Latch to the Latched position
4. Connect a jumper wire between the test points: control terminal 3 & Ground
5. Momentarily connect a 15 A fused jumper wire between the test points: Control terminal 4 & 12 V

   Verify the A23C Liftgate Latch performs the Unlatch function

   • If the A23C Liftgate Latch does not Unlatch 

     Replace the component: A23C Liftgate Latch

   • Go to next step: If the A23C Liftgate Latch does Unlatch 
6. All OK.

E7AC Rear License Plate Lamp Module

1. Ignition/Vehicle - Off
2. Disconnect the electrical connector: E7AC Rear License Plate Lamp Module
3. Test for infinite resistance between the test points: Signal terminal 3 & Ground terminal 1 - Not Pressed
   • If less than infinite resistance 

     Replace the component: E7AC Rear License Plate Lamp Module

   • Go to next step: If infinite resistance 
4. Test for less than 3 ohms between the test points: Signal terminal 3 & Ground terminal 1 - Pressed
   • If 3 ohms or greater 

     Replace the component: E7AC Rear License Plate Lamp Module

   • Go to next step: If less than 3 ohms