Circuit/System Verification
- Ignition - On/Vehicle - In Service Mode
- Verify the scan tool parameter: Rear Gate Close Switch = Inactive
- If not the specified state
Refer to Circuit/System Testing
- Go to next step: If the specified state
- If not the specified state
- Operate the component: B70 Liftgate Close Switch - Pressed
Verify the scan tool parameter: Rear Gate Close Switch = Active
- If not the specified state
Refer to Circuit/System Testing
- Go to next step: If the specified state
- If not the specified state
- A fault is not currently present and may be an intermittent condition