Removal Procedure
WARNING:
Refer to Cracked Window Warning .
WARNING:
Refer to Glass and Sheet Metal Handling Warning .
NOTE:
Before cutting out a quarter window, apply a double layer of masking tape around the perimeter of the painted surfaces and the interior trim.
- Quarter Panel Upper Applique - Remove -
- Quarter Lower Rear Trim Panel - Remove -, or
- NOTE:
Keep the cutting edge of the knife/tool against the window. Do this from inside the vehicle.
If necessary, use a long utility knife or similar tool to remove the bottom corners of the window from the urethane adhesive.
Remove the window from the urethane adhesive.
- Leave a base of urethane approximately 2 mm (0.078 in) on the pinch-weld flange.
- The only suitable lubrication is clear water.
- Use J 24402-A glass sealant (cold knife) remover, J 39032 stationary glass removal tool, or equivalent to remove the window.
Body Side Window (2) - Remove