Installation Procedure
WARNING: This page is about a different car, the 2018 Buick Regal TourX and 2018 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
Rear Coil Spring Lower Insulator(2) - Install
- Rear Coil Spring Insulator(3) - Install
- Rear Coil Spring(1) - Install
Raise the rear suspension lower control arm (1) back into position. Lower Control Arm Replacement (FWD) Lower Control Arm Replacement (AWD)
Rear Suspension Lower Control Arm Bolt(2) - Install
Install a NEW bolt.
- Rear Suspension Lower Control Arm Nut(1) - Install
Tighten
- First Pass: 160 N.m (118 lb ft)
- Final Pass: (90 - 105 degrees)
Rear Shock Absorber Bolt(2) - Install
Install a NEW bolt.
- Rear Shock Absorber Nut(1) - Install
Tighten
- First Pass: 160 N.m (118 lb ft)
- Final Pass: (90 - 105 degrees)
Rear Stabilizer Shaft Link Bolt(2) - Install
- Rear Stabilizer Shaft Link Nut(1) - Install
Tighten 58 N.m (43 lb ft)
- Remove the support from the rear suspension lower control arm.
- Install the rear tire and wheel assembly. Tire and Wheel Removal and Installation
CAUTION:
Refer to Fastener Caution .
CAUTION:
This vehicle is equipped with torque-to-yield or single use fasteners. Install a NEW torque-to-yield or single use fastener when installing this component. Failure to replace the torque-to-yield or single use fastener could cause damage to the vehicle or component.