Fastener Specifications (2.0L LTG)
WARNING: This page is about a different car, the 2018 Buick Regal TourX and 2018 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
Single Use Non-Threaded Fasteners/Components
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|---|
| Application |
| Engine Coolant Air Bleed Pipe O-Ring |
| Engine Coolant Thermostat Housing Seal |
| Thermostat Bypass Pipe Gasket |
| Turbocharger Coolant Feed Pipe Copper Washer |
| Turbocharger Coolant Feed Pipe Gasket |
| Turbocharger Coolant Return Pipe Washer |
| Water Outlet Seal |
| Water Pump Seal |
Reusable Threaded Fastener Tightening Specifications
|
NOTE:
All fasteners listed in this table can be reused after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Engine Coolant Air Bleed Pipe Bolt | 9N.m (80 lb in) |
| Engine Coolant Fan Shroud Bolt | 5.1N.m (45 lb in) |
| Engine Coolant Heater | 50N.m (37 lb ft) |
| Engine Coolant Thermostat Housing Bolt | 10N.m (89 lb in) |
| Front Bumper Shutter Bolt | 2.5N.m (22 lb in) |
| Ground Cable Nut | 9N.m (80 lb in) |
| Radiator Air Lower Baffle Bolt | 2.5N.m (22 lb in) |
| Radiator Surge Tank Bolt | 9N.m (80 lb in) |
| Radiator Upper Bracket Nut | 7N.m (62 lb in) |
| Radiator Upper Mount Bracket Bolt | 7N.m (62 lb in) |
| Thermostat Bypass Pipe Bolt | 10N.m (89 lb in) |
| Transmission Fluid Cooler Pipe Bolt | 5.1N.m (45 lb in) |
| Turbocharger Coolant Feed Pipe Fastener | 10N.m (89 lb in) |
| Turbocharger Coolant Feed Pipe Hollow Screw | 35N.m (26 lb ft) |
| Turbocharger Coolant Return Pipe Banjo Bolt | 35N.m (26 lb ft) |
| Turbocharger Coolant Return Pipe Bracket Bolt | 10N.m (89 lb in) |
| Water Outlet Fastener | 12N.m (106 lb in) |
| Water Pump Bolt | 25N.m (18 lb ft) |