LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2019 >> Envision Base >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Inflatable Restraint System >> Diagnostic Information and Procedures >> DTC B0080 >> Circuit/System Testing

Circuit/System Testing

IMPORTANT:

When removing connectors, inspect for damage or corrosion. Damage or corrosion in the following requires repair or replacement of the affected component/connector:

  • Passenger seat position sensor
  • SDM
  • Passenger seat position sensor wiring harness connector
  • SDM wiring harness connector
  1. Ignition OFF, disconnect the harness connector at the passenger seat position sensor.
  2. Test for less than 10 ohms between low reference circuit terminal 1 and ground.
    • If greater than the specified range, test the low reference circuit for an open/high resistance. If the circuit tests normal, replace the SDM.
  3. Ignition ON, test for 4.5 - 5.5 volts between the signal circuit terminal 2 and ground.
    • If less that the specified range, test the signal circuit for an open/high resistance or a short to ground. If the circuit tests normal, replace the SDM.
    • If greater that the specified range, test the signal circuit for a short to voltage. If the circuit tests normal, replace the SDM.
  4. If the circuits test normal, test or replace the passenger seat position sensor.
scientia non olet · About LEMON Manuals