LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2019 >> Envision Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 80 (Power Transfer Unit/Transfer Case - AAM) >> Repair Instructions - On Vehicle >> Transfer Case Bracket Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2018 Buick Envision. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM3824202Courtesy of GENERAL MOTORS COMPANY

    Position the bracket (6) to the transfer case.

    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the transfer case-to-transmission bolts (2, 3) and tighten to 22 N.m (16 lb ft).
  3. Install the transfer case-to-transmission bolt (1) and tighten to 22 N.m (16 lb ft).
  4. Install the transfer case-to-transmission bolt (4, 5) and tighten to 58 N.m (43 lb ft).
  5. Install the right wheel drive shaft. Refer to Front Wheel Drive Shaft Replacement - Right Side (MHG, M2D With F46)Front Wheel Drive Shaft Replacement - Right Side (MHG, M2D Without F46) .
  6. Install the exhaust front pipe. Refer to Exhaust Front Pipe Replacement (LTG)Exhaust Front Pipe Replacement (LCV) .
scientia non olet · About LEMON Manuals