LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2019 >> Encore Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 90 (Antilock Brake System) >> Repair Instructions >> Rear Wheel Speed Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2018 Chevrolet Trax and 2018 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:

Refer to Brake Dust Warning .

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  3. Remove the rear wheelhouse panel liner. Refer to Rear Wheelhouse Liner Replacement .
  4. GM2768790

    Disconnect the wheel speed sensor electrical connector (1) and release the connector clip from the wheelhouse bracket.

  5. Release the wheel speed sensor harness clip (2) from the wheelhouse panel.
  6. GM2768792

    Release the wheel speed sensor harness clips (1) from the rear axle.

  7. GM2768794

    Remove the wheel speed sensor bolt (1).

  8. GM2768795

    Remove the wheel speed sensor (1) from the rear suspension knuckle.

scientia non olet · About LEMON Manuals