Transfer Case Adapter Disassemble

WARNING: This page is about a different car, the 2018 Chevrolet Trax and 2018 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.

Callout	Component Name
1	Transfer Case Adapter
2	Transfer Case Adapter Seal
3	Transfer Case Adapter Bushing Procedure Install the DT 50839 onto the adapter and over the bushing. Install the CH 50342 threaded rod through the bushing and DT 50839. Install the CH 50342 washers, nuts, and bearing onto the rod. Install the bearing onto the rod at the end closest to the DT 50839. Tighten the nuts until snug. Hold the flat on the threaded rod and rotate the top nut to remove the bushing from the bore of the adapter. Special Tools DT 50839 Transmission Adapter Plate Bushing Replacer CH 50342 Hardware Kit For equivalent regional tools, refer to Special Tools .

Callout

Component Name

Transfer Case Adapter

Transfer Case Adapter Seal

Transfer Case Adapter Bushing

Procedure

Install the DT 50839 onto the adapter and over the bushing.
Install the CH 50342 threaded rod through the bushing and DT 50839.
Install the CH 50342 washers, nuts, and bearing onto the rod. Install the bearing onto the rod at the end closest to the DT 50839.
Tighten the nuts until snug.
Hold the flat on the threaded rod and rotate the top nut to remove the bushing from the bore of the adapter.

Special Tools

DT 50839 Transmission Adapter Plate Bushing Replacer
CH 50342 Hardware Kit

For equivalent regional tools, refer to Special Tools .