LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2018 >> Regal GS >> Repair and Diagnosis (Single Page) >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls And Fuel - 3.6L (LGX) - Repair Instructions >> Repair Instructions >> Fuel Pump Power Control Module Replacement >> Installation Procedure

Installation Procedure

  1. GM4598870Courtesy of GENERAL MOTORS COMPANY

    Fuel Pump Power Control Module(2) - Install

  2. Connect the electrical connector.(1)
  3. GM4589385Courtesy of GENERAL MOTORS COMPANY

    Fuel Pump Power Control Module(1)@Bracket(2) - Install - Rotate counterclockwise

  4. GM4589383Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to:Fastener Caution

    Fuel Pump Power Control Module Bolt(2) - Install and tighten 9 N.m (80 lb in)

  5. Fuel Pump Power Control Module Nut(1) - Install and tighten 9 N.m (80 lb in)
  6. GM4598869Courtesy of GENERAL MOTORS COMPANY

    Wiring Harness Retainer(1) - Install

  7. GM4589384Courtesy of GENERAL MOTORS COMPANY

    Wiring Harness Retainer(1) - Install

  8. GM4589382Courtesy of GENERAL MOTORS COMPANY

    Electrical Connector(3)@Clip(1) - Install

  9. Connect the electrical connector.(2)
  10. Lower the vehicle.
  11. Connect the battery negative cable. BATTERY NEGATIVE CABLE DISCONNECTION AND CONNECTION (3.6L LGX)
scientia non olet · About LEMON Manuals