Power Transfer Unit Propeller Shaft Seal and Rear Output Shaft Seal Installation

WARNING: This page is about a different variant/trim than selected.

Callout	Component Name
1	Power Transfer Unit Output Shaft Seal Procedure Install a NEW seal. Make sure the seal bore is clean and free of oil or dirt. Special Tools DT-51467 - A Seal Installer DT-305 - 1 Driver Handle Equivalent regional tools: Special Tools
2	Power Transfer Unit Propeller Shaft Seal NOTE: Install a NEW seal.
3	Power Transfer Unit Propeller Shaft Retainer Procedure Install a NEW retainer. When installing a NEW half shaft retaining clip, open the clip only as far as necessary to fit the clip over the shaft. Opening the clip too far will damage it. Start one end of the clip in the shaft groove and slowly push the clip onto and over the shaft.

Callout

Component Name

Power Transfer Unit Output Shaft Seal

Procedure

Special Tools

Equivalent regional tools: Special Tools

Power Transfer Unit Propeller Shaft Seal

NOTE:

Install a NEW seal.

Power Transfer Unit Propeller Shaft Retainer

Procedure

Install a NEW retainer.
When installing a NEW half shaft retaining clip, open the clip only as far as necessary to fit the clip over the shaft. Opening the clip too far will damage it.
Start one end of the clip in the shaft groove and slowly push the clip onto and over the shaft.