Installation Procedure
Connect the battery positive cable retainers (1) to the transmission studs and transmission case.
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
- CAUTION:
Refer to Fastener Caution .
Install the battery positive cable terminal (2) to the generator stud (3) and tighten the fastener (1) to 15 N.m (11 lb ft).
Connect the battery positive cable terminal (1) to the starter solenoid (3) and tighten the fastener (2) to 12 N.m (106 lb in).
- Lower the vehicle.
Install the battery negative ground cable terminal (1) to the engine block and tighten the fastener (2) to 40 N.m (30 lb ft).
Install the battery negative ground cable terminal (1) and tighten the fastener (2) to 22 N.m (16 lb ft).
Install the battery positive cable (3) to the battery fuse block and tighten the fastener (2) to 12 N.m (106 lb in).
- Close the battery fuse block cover (1).
- Install the radiator inlet hose to the water outlet. Refer to Radiator Inlet Hose Replacement (LTG) .
- Install the heater inlet hose to the water outlet. Refer to Heater Inlet Hose Replacement (LTG) .
- Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .