LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2018 >> Enclave Base >> Repair and Diagnosis >> Steering >> Steering Wheel And Steering Column >> Repair Instructions >> Intermediate Steering Shaft Replacement >> Installation Procedure

Installation Procedure

  1. GM4751146

    Position the intermediate steering shaft (1) in the vehicle.

  2. GM4751145

    Intermediate Steering Shaft (2) @ Steering Gear - Install

    3. CAUTION:

    Refer to Fastener Caution .

  3. Intermediate Steering Shaft Lower Bolt (1) - Install and tighten 55 N.m (41 lb ft)
    1. Clean the threads of the bolt with denatured alcohol or equivalent and allow to dry.
    2. Apply thread locking adhesive to the bolt. Adhesives, Fluids, Lubricants, and Sealers 
  4. GM4751144

    Intermediate Steering Shaft (2) @ Steering Column - Install

  5. Intermediate Steering Shaft Upper Bolt (1) - Install and tighten 42 N.m (31 lb ft)
    1. Clean the threads of the bolt with denatured alcohol or equivalent and allow to dry.
    2. Apply thread locking adhesive to the bolt. Adhesives, Fluids, Lubricants, and Sealers 
  6. Center the steering angle sensor. Steering Wheel Angle Sensor Centering
scientia non olet · About LEMON Manuals