LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2018 >> Enclave Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 26 (Supplemental Inflatable Restraint System) >> Repair Instructions >> Airbag Steering Wheel Module Replacement

Airbag Steering Wheel Module Replacement

WARNING: This page is about a different car, the 2017 GMC Acadia Limited, 2017 Chevrolet Traverse, and 2017 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Airbag Steering Wheel Module
GM1839343Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
WARNING:

Refer to SIR Inflator Module Handling and Storage Warning .

WARNING:

Refer to SIR Warning .

Preliminary Procedures

  1. Disable the SIR. Refer to SIR Disabling and Enabling .
  2. On the sides of the steering wheel are 2 circular openings, place the wheel so that one opening is on top.
  3. Using a blunt-ended tool, push the spring fastener inward through the access hole. Repeat the step for the other opening.
1 Steering Wheel Inflatable Restraint Module Assembly
WARNING:

After installation of the steering wheel airbag module to the steering wheel, slightly pull the module outward. If there is no give on the airbag module then it is secured correctly. If the airbag module is not fully attached personal injury could result.

Procedure

  1. Release the connector position assurance (CPA) retainer.
  2. Disconnect the electrical connectors.
  3. Refer to Inflatable Restraint Module Handling and Scrapping .
scientia non olet · About LEMON Manuals