Removal Procedure
WARNING:
CAUTION:
Always connect or disconnect the wiring harness connector from the EBCM/EBTCM with the ignition switch in the OFF position. Failure to observe this precaution could result in damage to the EBCM/EBTCM.
- Place the ignition switch in the OFF position.
- Air Cleaner Outlet Duct 1 - Remove - Air Cleaner Outlet Duct Replacement
- Without draining the coolant and without disconnecting the hoses, remove and position aside the radiator surge tank. Radiator Surge Tank Replacement (LGX FWD)Radiator Surge Tank Replacement (LGX AWD)
- Thoroughly clean the electronic brake control module (EBCM) to brake pressure modulator valve (BPMV) area of any accumulated dirt and debris.
- EBCM Electrical Connector 1 - Disconnect
- Right Front Brake Pipe Fitting 1 - Disconnect
- Cap the brake pipe fitting and plug the BPMV outlet port to prevent brake fluid loss and contamination.
- Left Rear Brake Pipe Fitting 1 - Disconnect
- Cap the brake pipe fitting and plug the BPMV outlet port to prevent brake fluid loss and contamination.
- Right Rear Brake Pipe Fitting 1 - Disconnect
- Cap the brake pipe fitting and plug the BPMV outlet port to prevent brake fluid loss and contamination.
- Left Front Brake Pipe Fitting 1 - Disconnect
- Cap the brake pipe fitting and plug the BPMV outlet port to prevent brake fluid loss and contamination.
- Brake Pressure Modulator Valve Secondary Pipe Fitting 1 - Disconnect
- Cap the brake pipe fitting and plug the BPMV inlet port to prevent brake fluid loss and contamination.
- Brake Pressure Modulator Valve Primary Pipe Fitting 1 - Disconnect
- Cap the brake pipe fitting and plug the BPMV inlet port to prevent brake fluid loss and contamination.
- Brake Pressure Modulator Valve Bracket Nut 1 - Loosen
- Brake Pressure Modulator Valve Bracket Nut 1 - Remove
- Brake Pressure Modulator Valve Bracket Bolt 1 - Remove
- Electronic Traction Control Brake Pressure Modulator Valve 1 - Remove