LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2017 >> Envision Base >> Repair and Diagnosis >> Steering >> Steering Wheel And Steering Column >> Repair Instructions >> Steering Column Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Steering Column
    GM3898444Courtesy of GENERAL MOTORS COMPANY
  1. Position the steering column (1) in the vehicle.
    2. Fig 2: Steering Column Nuts (With Tightening Sequence)
    GM4663837Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  2. Install and hand tighten Steering Column Nuts (1) (Qty: 4)
  3. Tighten the steering column nuts (1) in sequence shown to 22 N.m (16 lb ft).
  4. Connect the steering column electrical connectors.
  5. Install Intermediate Steering Shaft @ Steering Column. Refer to Intermediate Steering Shaft Replacement 
    6. Fig 3: Instrument Panel Knee Bolster
    GM3906064Courtesy of GENERAL MOTORS COMPANY
  6. Install Instrument Panel Knee Bolster (2). Refer to Instrument Panel Knee Bolster Replacement
    7. Fig 4: Floor Front Air Outlet Duct - Left Side
    GM3821422Courtesy of GENERAL MOTORS COMPANY
  7. Install Floor Front Air Outlet Duct - Left Side (2). Refer to Floor Front Air Outlet Duct Replacement - Left Side
    8. Fig 5: Steering Column Lower Trim Cover
    GM3909980Courtesy of GENERAL MOTORS COMPANY
  8. Install Steering Column Lower Trim Cover (2). Refer to Steering Column Lower Trim Cover Replacement 
    9. Fig 6: Instrument Panel Steering Column Upper Trim Cover
    GM4622445Courtesy of GENERAL MOTORS COMPANY
  9. Install Steering Column Upper Trim Cover (1). Refer to Steering Column Upper Trim Cover Replacement 
  10. Program the power steering control module. Refer to Control Module References
  11. Center the steering angle sensor. Refer to Steering Wheel Angle Sensor Centering
scientia non olet · About LEMON Manuals