Component Testing

Relay Test

1. Ignition OFF, disconnect the KR2 headlamp washer pump relay.
2. Test for 60 - 200 Ω between terminals 2 and 1.
   • If less than 60 or greater than 200 

     Replace the KR2 headlamp washer pump relay.

   • If between 60 - 200 Ω 
3. Test for infinite resistance between the terminals listed below:
   • 3 and 1
   • 3 and 5
   • 3 and 2
   • 2 and 5
   • If less than infinite resistance 

     Replace the KR2 headlamp washer pump relay.

   • If infinite resistance 
4. Install a 10 A fused jumper wire between relay terminal 2 and 12 V. Install a jumper wire between relay terminal 1 and ground.
5. Test for less than 10 Ω between terminals 3 and 5.
   • If 10 Ω or greater 

     Replace the KR2 headlamp washer pump relay.

   • If less than 10 Ω 
6. All OK.