Circuit/System Verification
- Ignition ON.
- Verify that no other DTCs are set except for C0544.
- If any other DTCs are set
- If no other DTCs are set
- With a scan tool, verify that the Steering Wheel Angle parameter is zero degrees or near zero degrees with the front tire/wheels in the straight ahead position.
- The Steering Wheel Angle parameter is not zero degrees or near zero degrees
Perform the Power Steering Control Module Calibration. Refer to Power Steering Control Module Calibration
- The Steering Wheel Angle parameter is zero degrees or near zero degrees
- The Steering Wheel Angle parameter is not zero degrees or near zero degrees
- Verify that DTC C0544 is not set.
- If the DTC is set
Replace the K43 Power Steering Control Module.
- If the DTC is not set
- If the DTC is set
- All OK.