LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2016 >> Envision >> Repair and Diagnosis (Single Page) >> Electrical >> Body Electrical >> Wiring Systems And Power Management - Diagnostic Information And Procedures >> Diagnostic Information and Procedures >> DTC P156D: DC/DC Converter Ignition Switch Run/Start Position Signal Message Counter >> Circuit/System Testing

Circuit/System Testing

  1. Verify that no other DTCs are set except for DTC P156D.
    • If only DTC P156D is set 
  2. Replace the T19 Power Supply Transformer.
  3. Verify the DTC does not set while operating the vehicle within the Conditions for Running the DTC.
    • If DTC sets 

      Replace the K20 Engine Control Module.

    • If DTC does not set 
  4. All OK.
scientia non olet · About LEMON Manuals