LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2016 >> Encore Base, AWD >> Repair and Diagnosis >> Steering >> Power Steering System >> Repair Instructions >> Power Steering Gear Inlet Pipe/Hose Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Power Steering Gear Inlet And Outlet Hoses
    GM2808015Courtesy of GENERAL MOTORS COMPANY
  1. Position the power steering gear inlet hose (2) on the vehicle.
  2. Power Steering Gear Outlet Hose Seal 4 - Install

    Install a NEW seal.

  3. Power Steering Gear Inlet Hose Seal 4 - Install

    Install a NEW seal.

  4. Power Steering Gear Outlet Hose 3 @Steering Gear - Install
  5. Power Steering Gear Inlet Hose 2 @Steering Gear - Install
    6. CAUTION:

    Refer to Fastener Caution .

  6. Power Steering Gear Inlet and Outlet Hose Bolt 1 - Install and tighten 11 N.m (97 lb in)
    7. Fig 2: Power Steering Gear Inlet Hose And Bracket
    GM2808014Courtesy of GENERAL MOTORS COMPANY
  7. Secure the power steering gear inlet hose (3) to the drivetrain and front suspension frame using the plastic push pin (2) and the power steering gear inlet hose bracket bolt (1).
  8. Power Steering Gear Inlet Hose Bracket Bolt 1 - Install and tighten 9 N.m (80 lb in)
    9. Fig 3: Steering Gear Inlet Hose
    GM2808013Courtesy of GENERAL MOTORS COMPANY
  9. Secure the power steering gear inlet hose (2) to the engine using the power steering gear inlet hose bracket bolt (1).
  10. Power Steering Gear Inlet Hose Bracket Bolt 1 - Install and tighten 22 N.m (16 lb ft)
    11. Fig 4: Power Steering Gear Inlet Hose And Seal
    GM2808012Courtesy of GENERAL MOTORS COMPANY
  11. Power Steering Gear Inlet Hose Seal 2 - Install

    Install a NEW seal.

    12. CAUTION:

    Refer to Component Fastener Tightening Caution .

  12. Power Steering Gear Inlet Hose 1 @Power Steering Pump - Install and tighten 34 N.m (25 lb ft)
  13. Fill and bleed the power steering system. Power Steering System Bleeding 
scientia non olet · About LEMON Manuals